• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

General TR Moto-Lita wheel refinishing

Share this page

Kirk_Fisher

Kirk_Fisher

Jedi Hopeful
Offline
Last steps of flood restoration. Interior is going back in. I need to refinish the steering wheel. Anyone ever done this? Process and product recommendations?
 
Can we have a look at it?
We will then be able to make better recommendations.
If the wheel is wood and shot, sand and plastic coat then cover with a leather wheel skin.
 
Aluminum. The finish is yellow and cracked. The wood looks ok.
 
Kirk, It sounds like the clear coat has gone bad on the aluminum and needs to be stripped. No big deal, just buy some stripper from your local hardware store and do the wood at the same time. After all has been cleaner with denatured alcohol tape the wood to keep wax off, polish the aluminum, clean again with the alcohol now you can spray it all with clear poly, not lacquer. Give it two or three coats, sand with 2000 grit wet and dry sandpaper with soap and water, spray 3 more coats and do it one more time and it will look like new.


Wayne
 
Back
Top