• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Moss Top Boot Fitting Problem

Share this page

6

67BJ8

Senior Member
Offline
I bought a new Moss Motors top boot for my 1967 BJ8.
It looks like it is going to be too small to fit. Is
this typical? Is there a trick to make it fit? I will
have to stretch it to the limit to even have a chance to
make it work.
 
I bought the same top from Moss a few years ago. I remember it came with the hardware seperately and someone else had to attach the Tenax fasteners to the boot material. I had a boat upolstery place do mine here in Seattle. They did an OK job but still a tight fit. Try letting it sit in the sun awhile to warm up and give it another try. Also it works for me if I attach the rear fasteners first then work to the front corners.
Good Luck!
 
I still have the original and a replacement. Both fit very tight. A real key is to make sure the top is pushed as far down as possible. Sometimes the top bunches up when folding down. My new stayfast top seems to compress tighter than the previous vinyl one. As stated before, warm the boot up in the sun first. I have even tossed mine in the clothes dryer for a couple of minutes.
 
Back
Top