• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

mech. water temp gauge repair? have you tried this

Share this page

I have used the method described in that web link and it does work. However, having repaired only two gauges I'm not proficient at the task.

I have an observation about the mechanical temp gauge repairs that I would like to pass along. If the needle of the gauge you want to repair is not sitting on zero (or more correctly the stop peg) at room temperature, the Bourdon tube is likely stretched/damaged. Such a gauge will take a lot more work to calibrate than one which has the needle properly resting on the stop peg from the start.
 
I've done it on several occasions, and have had no problems. The real key to this is the piece you use to splice the the two tubes together...the one from the original gauge, and the one from the donor gauge. The donor gauge you will use will most likely have a slightly smaller diameter then the tube coming from your original gauge. You have to get both ends to fit faily well, which will mean drilling with different size drill bits. The solder joint MUST be good, or the ether will leak out and then it's start over with another donor. Carefully inspect the solder joint BEFORE you take the bulb out of the salt/ice slurry. Other then that, follow the instructions and it will work.

I repaired the one on my TR3 a couple of years ago, and it's still working fine.

BTW, the slurry of ice water and salt dropped the temp down to below 0 deg F. Plenty cold enough to keep the ether in the bulb.
 
This is next on my list for the Sprite, and I am really nervous to do it.
 
I repaired one using those instructions and it went OK.
 
Back
Top