-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Master Cylinder Question
- Thread starter JPSmit
- Start date
Share this page
Gerard
Luke Skywalker
Offline
The brake master cylinder remained unchanged (3/4") to the end of production, but for the clutch there were two different bore sizes. Typically 3/4", but with designated markings can be (if I remember correctly) 11/16".
https://www.mossmotors.com/graphics/products/info/mstrcylid.gif
https://www.mossmotors.com/graphics/products/info/mstrcylid.gif
G
Guest
Guest
Guest
Offline
That would be the big hole inna middle. :wink: