Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Anyone have one of these? Lost the instructions.I know you measure the back of the front tires with the gauge,lock the measurement and then move the gauge to the front. There was something about adjusting the front tie rod untill the gauge shows....here's the part I'm uncertain about....1/2 of the rear measurement? Have I got that right? Is the TR3 toe in 1/16th"? I think the gauge is in 32 seconds. I know there are a lot of good DIY methods for doing the alignment but seeing as how I already have the gauge I may as well go with it.
-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
TR2/3/3A Manco wheel alignment gage...
- Thread starter karls59tr
- Start date
Share this page
pa297pass
Jedi Trainee
Offline
I have done the same, lost the instructions. Looks like
someone on the MG Experience posted a photo of the instruction sheet.
https://www.mgexp.com/forum/mgb-and-gt-forum.1/cen-tech-toe-gauge-instructions-needed.3259815/
Matt
someone on the MG Experience posted a photo of the instruction sheet.
https://www.mgexp.com/forum/mgb-and-gt-forum.1/cen-tech-toe-gauge-instructions-needed.3259815/
Matt