SOLD!! Magnetic Aluminum Alloy Fuel Cap for TR250 and pre-1970 TR6

[90DegreesSouth]

Hopefully you can see the photos. If not here are some key points:

• Aluminum alloy (not polished, no chrome)
• Magnetic only, no latch
• Has vent hole below the lid opposite the hinge (vents to the outside)
• Opens to slightly more than 90 degrees (let's call it 100)
• 2 inch OD for filler pipe (1.66 inches long)
• 4.4 inch at widest point
• Approx. 1.5 inches from bottom of base to top of dome
• Has rubber grommet that goes between base of filler and mounting hole in rear deck

Please PM if interested.
Thanks,
Mark

Filler Neck

Fully open

Rubber Mounting Grommet

Vent hole

 

[Rpierce]

Hi Mark, Russ Pierce from Warner Robins, GA here. If you still have the fuel cap I’m interested in talking to you about it. Thanks

 

[Marvin Gruber]

If Russ doesn’t buy it I would be interested