Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
ike_cloe58
Freshman Member
Offline
I just pulled my engine and was trying to locate a quality machine shop in Albuquerque to have the block bored, crank turned and so forth?
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Machine Shop In Albuquerque
- Thread starter ike_cloe58
- Start date
Share this page
Offline
Call Dan over at Danco: 505-299-8110
They are located at 9808 Cochiti Rd SE
(Its one block south of Central and a few blocks east of Wyoming).
I have had several heads done (including a Jag EType) and have been very impressed with the quality of his work and also his prices are very reasonable.
Basil
They are located at 9808 Cochiti Rd SE
(Its one block south of Central and a few blocks east of Wyoming).
I have had several heads done (including a Jag EType) and have been very impressed with the quality of his work and also his prices are very reasonable.
Basil
OP
ike_cloe58
Freshman Member
Offline
Thank you I will give them a call.