Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
livinginthepast
Jedi Trainee
Offline
61 BE 948.
I am installing the steel oil line that starts at the oil filter canister mount with a pressure fitting and runs towards the back of the engine block and connecting to it with a banjo union. Anyhoo, the PO ran a hose between these two points and I'm finally getting around to fixing it.
Question - is there a torque setting called out for the banjo fitting, or is it just a matter of tightening 'just enough?'
Thx!
I am installing the steel oil line that starts at the oil filter canister mount with a pressure fitting and runs towards the back of the engine block and connecting to it with a banjo union. Anyhoo, the PO ran a hose between these two points and I'm finally getting around to fixing it.
Question - is there a torque setting called out for the banjo fitting, or is it just a matter of tightening 'just enough?'
Thx!
