Interior - side pannels

[Donny_L]

The side pnls for the back of my 61 AH 3000 are shot. I've been trying to fabricate some replacements. The old ones were made of some kind of thin plastic and when I took them off they completely crumbled into little pieces. Have any of you done this project? What did you use? Where did you get it from? I have to make this work because the ones I've seen in ordering catalogs are way to $ rich $ for my blood.

 

[KSIS]

I just redid the trunk and kidney panels in my TR6. I took a trip down to Lowes and looked at the section for yard signs. See what the may have for you.

 

[AEW]

I don't know for sure if this will help. It's been a long time since I bought anything from them, but they probably can match whatever plastic material was in the door panel if you can describe it to them.

PORT PLASTICS
7500 SW Tech Center Dr # 100
Portland, OR 97223-8058
(503) 684-9335

 

[elrey]

I rooted thru my Moss boxes and found the rear panels. Would you like a tracing? --elrey 61 BT7

 

[Donny_L]

Hey Elrey, a tracing would be great ! I can measure and take some pic's of the sticks for ya.

 

[elrey]

Righty-O. --elrey