• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

T-Series IgnitionSwitch removal

Share this page

mdionne

mdionne

Member
Offline
I have searched for the answer but can't find it. Can someone tell me how to remove the ignition switch assembly from the steering column of a 79 midget? I have removed the steering wheel and plastic covers over the turn signals and wipers. I have taken out the four bolts that hold the column to the body. I see the two headless bolts. Now what? Will I need to remove the entire column? How do you remove those bolts?

I am removing it because I am replacing the whole thing.

Thanks!
 
IIRC you have cut grooves into the headless bolts.
 
Yes- either cut a groove in each "headless" bolt (use a Dremel or similar) and use a common screwdriver to remove
-or-
Drill a hole (maybe 3/16" diameter, about 1/4" deep) in each bolt and use an "easy out" on each one. (the Dremel and screwdriver IS easier!!)
BillM
 
Back
Top