• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Ignition Swich replacement

Share this page

R6MGS

R6MGS

Yoda
Offline
I am seriously considering a truck....The only issue with it is that someone broke off the upper tab of the ignition switch....still works fine, but it's a bit of a pain to start without a tab to push against. Since my mechanic isn't reachable on Sundays....or Saturday nights I was wondering if anyone had a ball park figure on how much this might cost to have it replaced....Unless anyone has any other ideas to make a new tab?
 
GM truck? The replacement is pretty straightforward. If I recall correctly, the steering wheel comes off, and there is a plate that gets pushed down (cheap special tool) and the switch comes out. If you have a tame locksmith, they can do it even faster.
 
Yup, 2000 GMC Sonoma....Thanks, would this be something I could do myself? How do u remove an air bag equiped steering wheel?
 
& then replace it with a non-air bag wheel!
 
Key to messing with airbags is to have the Battery disconnected. As long as that's done they're pretty safe as long as they're handled with care.
Basic safety with a bag it to never hold it facing away from you, or set it down face-down. If it ever went off you do not want the metal base to become a projectile.
Just treat it like a loaded gun, with the backside of the airbag as the barrell, and you'll be fine
Make sure all connecters are secured completely, and be careful with the "clock spring" connector under the wheel.
I would not perminantly remove an airbag from a newer car as that drastically affects it's resalability in some cases.
 
Back
Top