Hi Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
AweMan
Jedi Knight
Offline
I found several Used linde VI 400 mig welders with warrentees on the net up for auction at $800.00 each. Man If I only had 3 phaze current in my garage!
I used one of these welders back in the late 80`s for an extended period of time, WHAT A M.I.G. WELDER! That puppy would flat burn some wire. I can distinctly remember running the IPM at 6 and sometimes even 7 with .035 wire and 75/25 mix. That machine had good inductance and would run with very little spatter, usualy it would just "frost" the nozzle. If I was doing heavy fab work I would deffinately go after one.
It would not be the M.I.G. to get for body work tho.
I used one of these welders back in the late 80`s for an extended period of time, WHAT A M.I.G. WELDER! That puppy would flat burn some wire. I can distinctly remember running the IPM at 6 and sometimes even 7 with .035 wire and 75/25 mix. That machine had good inductance and would run with very little spatter, usualy it would just "frost" the nozzle. If I was doing heavy fab work I would deffinately go after one.
It would not be the M.I.G. to get for body work tho.
