• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

How do you keep after market rubber trim in place?

Share this page

6

67BJ8

Senior Member
Offline
I replaced all of the door surround trim on a BJ8 with new Moss material. The aluminum grips on it do not hold very well compared to the original steel ones. The trim keeps coming loose. Any ideas on how to keep the new trim in place?
 
[ QUOTE ]
I replaced all of the door surround trim on a BJ8 with new Moss material. The aluminum grips on it do not hold very well compared to the original steel ones. The trim keeps coming loose. Any ideas on how to keep the new trim in place?

[/ QUOTE ]

I pulled all mine off, squirted clear low modulus silicone bath sealant into the groove and put it back - works a charm so far.

/ubbthreads/images/graemlins/england.gif
 
I put the Healey stuff in the garbage can and purchased TR6 Material.-FWIW---Keoke
 
Re: How do you keep after market rubber trim in pl

Sometimes it helps to use a hammer (rubber of course) to tap it in place, even then some are a pain. Wayne
 
Keoke,
Do you have a photo of the TR6 trim that we might compare?
Lin Rose
1960 BT7 in restoration
1959 Bugeye
 
Re: How do you keep after market rubber trim in pl

I also am fed up with the Furflex I bought from Moss. Does the TR6 come in blue?

Thanks ...
 
Re: How do you keep after market rubber trim in pl

This is interesting. I have the moss stuff on for two plus years with out a problem. If I remember correctly there are metel teeth with barbs on them. You might try twisting the barbs and squeezing the metal to get a better bite avery two to four inches. I remember doing that at the ends.
 
Re: How do you keep after market rubber trim in pl

The stuff I got last winter had aluminum instead of a harder metal and it relaxes almost immediately. I've talked to a number of others at differenct shows and they have the same problem. Glueing is an option but I'd like to just get a better product.
 
No Lin , I do not have a sample. However the rubber seal is a little larger in diameter and it has the hard metal teeth not the floppy aluminum stuff used on the current Moss Healey version.
 
Re: How do you keep after market rubber trim in pl

/ubbthreads/images/graemlins/savewave.gif

TH "Metal teeth with barbs on them" that use to was the current material is plain junk.---Keoke
 
Back
Top