• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

head bolts 1275 motor

Share this page

F

flounder

Freshman Member
Offline
recently pulled the head from a 1275cc motor,would like to replace the head studs which are about 4" long 3/8" diameter with coarse threads on one end and fine threads on the other. does anyone know where i can buy them?
 
Short side ones usually get a lot more beat up over the years due to being outside the valve cover and exposed to head gasket leakage and lack of oil seepage. The ones on the inside of the valve cover get oil seepage from the top of the engine and usually are in better condition.

If you are looking for new stock type stuff, VB, Moss or a local shop will likely be your source.

If you are looking for aftermarket premium fastners (ARP) then, VB, Moss, APT, Summit, Jegs and the advertisers here are some likely sources. VB/Moss being the most costly and the discount mail order places the cheapest.

You can usually find used stock stuff with the members of this forum.
 
Back
Top