• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

TR2/3/3A Greasing the idler arm grease zirk???

Share this page

Does yours have a 90 degree zerk? It pretty much has to have one to reach it.
 
Last edited:
If you don't have one a rubber grease hose for your grease gun it might make all the differenc to you. Any auto parts house should have a rubber grease arm.

Cheers, Dick
 
Hah hah -- wait till you try to get at the zerk on the sliding spline on the propshaft.

I keep an assortment of grease gun attachments for narrow spots (some U-joints), right-angle attachment (said propshaft) and needles (for sneaking where no gun was supposed to go).

I've seen guns with rigid tubes instead of rubber -- no idea how that would be good.
 
Back
Top