• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Generator/dynamo bushing replacement

Share this page

F

Fred_Maves

Member
Offline
I have a new (soaked in warm oil) bushing. I could use some sage advice for removing the old one. I also need to remove my damaged armature. I am hoping to press it out without removing the riveted bearing enclosure. This is an early model gen. with tach. drive.
 
For pulling bronze pilot bushings I have always used tap to get some thread's started in them then screwed a bolt in and pried them out. Would try the same trick on that gen bushing.

Kurt.
 
Back
Top