Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Offline
Hello everyone!
It has been a while since I posted anything, mostly because it has been a while since I worked on my car, but I can't find any diagrams or info in this one.
I have a 69 Triumph GT6 + (Mark II) and the PO put in rubber fuel lines but I am pretty sure they are run incorrectly.
I am replacing them, but I can't figure out how to run them, specifically over (or under) the rear left half shaft (axle).
They are currently under and I can't see how that could be correct, in fact it seems a bit dangerous to me.
Anyway, if some one could tell me or even better take a few pics, I would greatly appreciate it.
Thanks
It has been a while since I posted anything, mostly because it has been a while since I worked on my car, but I can't find any diagrams or info in this one.
I have a 69 Triumph GT6 + (Mark II) and the PO put in rubber fuel lines but I am pretty sure they are run incorrectly.
I am replacing them, but I can't figure out how to run them, specifically over (or under) the rear left half shaft (axle).
They are currently under and I can't see how that could be correct, in fact it seems a bit dangerous to me.
Anyway, if some one could tell me or even better take a few pics, I would greatly appreciate it.
Thanks