• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Fuel Guage

Share this page

TR674

TR674

Jedi Warrior
Offline
Hello all and a happy new year.
My fuel guage as stopped working on a few occasions in the recent past. Going over a bump or taking a sharp corner usually restored operations. Now it is not working at all. Has the unit failed or are there numerous connections and/or earths secretly hidden that I need to check?
Regards
Craig
 
System is grounded at the tank sender: a potentiometer-like device. Check those connections (and may as well clean 'em while you're there) first. The gauge connections (two) as well. Voltage is supplied from a voltage stabiliser at 10V to the gauge thru the green/lt.green wire, then to the sender with the green/black one. If you ground the sender G/B wire the gauge ~should~ climb to "FULL". If not, it may be time to pull the gauge and repair/replace it. This also gives you an indication as to whether it's the gauge or the sender causing the problem.

As yours is a "later" car the gauge is likely one using induction coils to move the needle. It probably has one of the hair-thin wires vibrated to failure. Before condemning the instrument, check thru the above, and ohm out the wire to the rear as well. Rule out all the "dumb stuff" so-to-say.
 
DR, in your second paragraph are you talking about the "fast response" gauges? Those gauges use internal magnetic coils but they fell out of use during the mid-1960s when the stabilizer was introduced. To the best of my knowledge Smiths used the common bimetallic gauges from that point up until Austin/Rover started buying Nippon Seiki gauges.

The DR's test method is how to start. If with the ignition turned on grounding the green/black wire gives you a FULL gauge reading, focus your attention on the sender. If the test does not cause the gauge to read FULL, you must first confirm the continuity of the green/black wire between the tank and gauge. Once you know that the wire is OK you should look for problems with the sender.
 
You're right, Doug! Ack! Apples/oranges... exactly backwards. Apologies.

...I'll blame it on "oldtimer's disease." /bcforum/images/%%GRAEMLIN_URL%%/blush.gif /bcforum/images/%%GRAEMLIN_URL%%/crazy.gif
 
Back
Top