• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Ford Truck Help??

Share this page

G

GaryBeu

Banned
Offline
I'm putting new bearings in my F-250 steering column. There is a "bearing retainer ie: thrust washer" that's sort of cone shaped with a flat ring on the larger end. A spring guide with a flat end goes against it and then the spring and snap ring. QUESTION IS: Does the small end of the cone go INTO the bearing? Hope someone knows. Thanks.

Gary
 
Thanks but, never mind...we figured it out and it works great!!
 
Yes.

We used to use those parts to "upgrade" the hard rubber column bushings in much older Fords.
 
Back
Top