Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
I am trying to install a Bell stainless steel exhaust system on my 60 BT7. Problem is that the welded on bolts on the exhaust pipe are not lining up to the cars frame where the rubber mounts are to be installed. Weld to Weld is 36 inches while the rubber mounts are 34 inches apart. I noticed the old pipes were gerrymandered with strange pieces of metal to make the pipes fit also. Is there some sort of kit out there to allow me to adjust the spacing? Everything else seems to line up.
-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Exhaust system cunumgrums
- Thread starter Rick G
- Start date
Share this page
Bob_Spidell
Yoda
Offline
I may be missing something, but the rubber mounts can be installed either of two ways. The bracket on the mounts is offset an inch or so from the bolt holes, so mounting them bracket-to-bracket or bracket-away-from bracket could make at least a 2" difference.