• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Does this thing come off?

Share this page

R

RyanBez

Jedi Hopeful
Offline
From what I can tell it there is nothing really holding it on but it just wont budge...it looks like the main supports inside the car run along it and maybe one of those welds are holding it on? I just don't want to leave anything treated so I only have to do it once!

0wCDi.jpg
 
In the picture, the far left set of holes is where the u, or rather square, bolt holds the leaf spring (1/4) to the chassis. You can kind of see the start to the rear wheelwell on the left side of the picture.
 
They are welded to the floor. The floor under those plates may or may not have to be replaced. That area of the floor many times rusts out because it traps road grim between it and the spring. Water coming down from the area of the B post also can rust the area, just to the outside.

Paul
 
While it may be welded to the floor, it is important to put the 4 bolts in the holes to the right side of the picture. My first BE was really squirrelly in the turns...lots of oversteer...put the 4 bolts on a side on the spring plate, and it tightened right up.
Scott in CA
 
Back
Top