Hi Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Offline
Same 1954 100 that is almost done.
The motor was rebuilt around 1985ish and shrink wrapped.
Will add pic of dist as soon as I can figure out how to make smaller pixels to fit board.
However, the stamped numbers are
454 YH13
46422B
it has the screw type vacuum advance connection
It may or not have been replaced during the rebuild
Looking for the proper point set. Old ones are a bit corroded after 30 years of not being used.
The numbers on the distributor do not match anything at Moss or HS
Can any one help.
Again Thanks in Advance
The motor was rebuilt around 1985ish and shrink wrapped.
Will add pic of dist as soon as I can figure out how to make smaller pixels to fit board.
However, the stamped numbers are
454 YH13
46422B
it has the screw type vacuum advance connection
It may or not have been replaced during the rebuild
Looking for the proper point set. Old ones are a bit corroded after 30 years of not being used.
The numbers on the distributor do not match anything at Moss or HS
Can any one help.
Again Thanks in Advance
