• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Distributor Electricity Queston to start engine

Share this page

Bruce_B

Bruce_B

Jedi Warrior
Offline
I'm still working on my wiring,but the starter works and the ignition switch is wired up. Car is a 59 BE with a 1275 engine, positive ground.

What's the minimum "juice" that I need to start the engine?

I'm thinking that if the coil is hot, the distributor is attached to the coil and the starter motor is good to do that should be enough. I'll worry about the generator later on. I just want to start up the rebuilt engine.

Ideas?

Thanks....
 
Bruce, that's all you should need. Power to the coil, and enough to spin the starter. If you're running an electric fuel pump, that will have to be running as well.
Jeff
 
BUT,,, If you have a Pertronics and the voltage dips below
approx 10 Volts it wont start.
At least thats the case with mine. Battery ran down and would not quite turn it over tried to push start and it just did not work.
 
Thanks Jeff, Chris. I do have the Pertronics so I'll have to make sure there's a good charge on the battery.

So you can't push start a Pertronics...hmmmm. Makes sense when you think about it...I just never did.
 
I dont understand. I have a pertronix in my dist (1970 midget) and last week left lights on. Dead battery. pushed (by myself) jumped in, poped clutch and drove off....
 
It may make a difference what type charging system you have on the car.
 
Back
Top