• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

clutch pedal

Share this page

D

duplaga1952

Member
Offline
still having problems bleeding the clutch, but too cold to spend mutch time on it. did notice the pedal hits the footwell back wall. will this stop when the pressure is up after the clutch is bled? or is something wrong ,bent pedal?


thanks bob
 
should stop
 
Check the clevis pin on the clutch master connection make sure it’s not worn out this will cause a lot of free play.
 
texas_bugeye said:
Check the clevis pin on the clutch master connection make sure it’s not worn out this will cause a lot of free play.
Click to expand...

Yes!

The hole at the top of the pedal gets elongated with time.
Even a tiny bit of wear in this hole will translate into an inch or more of lost motion.
If the hole is worn and you have the setup, you can weld it closed and re-drill it.
 
Back
Top