• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

TR2/3/3A Clutch Operating Shaft with bolt hole in wrong location?

Share this page

K

karls59tr

Obi Wan
Bronze
Country flag
Offline
I've heard that at some point in time,not sure when,there was a bad batch of clutch operating shafts being sold that had the locating bolt hole in the incorrect location?.....anyone else heard this?
 
News to me. The locating bolt was deleted later on anyway, so IMO you could safely just leave it out. The fork touching the carrier will keep the shaft from going anywhere.
 
Sorry my mistake. I meant to say the the hole in the clutch shaft that takes the operating pin and locks the fork to the shaft was drilled in the wrong location.
 
Ah, that would certainly be more serious. But again, I've not heard of that one.
 
Back
Top