• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Clutch Bleeder Screw

Share this page

Tullamore

Tullamore

Jedi Warrior
Offline
What size thread is the bleeder screw on the slave cylinder of a 1966 Midget? I'm thinking of trying out a speed bleeder on it, any reason that is a bad idea?
 
3/8-24. even better is to run a 2 foot brake line up the inner fender from the slave bleeder hole. It is a 3/8 bubble (single) flare. Then get a union for the upper end, and install your current bleed screw into the union. Now you can bleed in comfort. Peter C.
 
Ho ho, Peter and Hap have the same solution. We got to keep these guys seperated, they could cause problems.
 
Back
Top