Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Getting ready to test fit the front on the bugeye for a pre-paint trial. Tips/steps for installing? Looks like a natural process for an octopus. Do you do props first? It's a standard factory lash up. re: hinged at the rear. How many people do you use? Inner fender bumpers? etc.
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Bugeye nose
- Thread starter rossco
- Start date
Share this page
Rhodyspit75
Jedi Knight
Offline
It’s much easier to start a nut onto a stud than a bolt into a hole. I have cut the head off of a bolt so that I have threads on both ends and put that into one hinge hole in each side Make sure that you have good clean threads that you are going to start the nut on. Put the stud through the hinge and put the nut and a washer on them and it will help line up the other bolts. Once you have the rest of the bolts started unscrew the studs and replace them with bolts. Best done with three people.