-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Bugeye body panels and replacement
- Thread starter Rut
- Start date
Share this page
Jim_Gruber
Yoda
Offline
Re: Bugeye body panels
Rut,
Need to be careful as some of the floors available need to be modified for the BE Gas Pedal mount. Who makes a correct replacement floor, AH Spares?
Rut,
Need to be careful as some of the floors available need to be modified for the BE Gas Pedal mount. Who makes a correct replacement floor, AH Spares?
OP
Rut
Obi Wan
Offline
Re: Bugeye body panels
Jim,
Thanks for the heads up, but I plan on using a 1500 gas pedal to give my 12.5s a little more room. I've started drilling out the spot welds and a few panels have started to separate. Since the damage to my existing floors is on both sides and there's some damage to the floor reinforcement as well as the brace that goes over the spring boxes I plan on replacing it all. That said, how do I support the car on jack stands in the rear while removing metal?
Thanks, Rut
Jim,
Thanks for the heads up, but I plan on using a 1500 gas pedal to give my 12.5s a little more room. I've started drilling out the spot welds and a few panels have started to separate. Since the damage to my existing floors is on both sides and there's some damage to the floor reinforcement as well as the brace that goes over the spring boxes I plan on replacing it all. That said, how do I support the car on jack stands in the rear while removing metal?
Thanks, Rut
apbos
Jedi Knight
Offline
Re: Bugeye body panels
Rut
Is your car stripped down? I think you will find it easier removing the floors with the car on its side or upside down. I used the ebay panels for patches for my B/E since I only needed to repair the driver side foot area. I have a passenger side in the box for cheap if you want. The quality is ok, but you can see the difference from the originals. No vents, for a 1500, some holes will have to be drilled.
Paul
Rut
Is your car stripped down? I think you will find it easier removing the floors with the car on its side or upside down. I used the ebay panels for patches for my B/E since I only needed to repair the driver side foot area. I have a passenger side in the box for cheap if you want. The quality is ok, but you can see the difference from the originals. No vents, for a 1500, some holes will have to be drilled.
Paul