• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Bugeye Body Blast

Share this page

talked to rocky mountain .. said they take care of all the rust, pitted or not .. good prices are well. looks like a trip in the near future for me. for those interested , and i know you're out there, ... just under $1K (approximately).
 
Good deal Fred! Rocky Mtn. has been doing this stuff on cars and huge industrial equipment for years. I think they sand blasted the bottom and passenger compartment and used soda where panels might warp and only paint removal was needed. Mine was done 4 years ago and has been on a rotisserie or now a stand and no rust has shown anywhere although the dust will keep coming from below the dash and frpm the trumpets over at least a couple of prime or paint coats. I had been thru this with media blasting and found revving up the leaf blower and trying to get as much residue out that way seemed to help.Just using a blow gun and compressor was not as effective. Rocky Mtn. does plastic media now also.
 
Thanks for the tip Tom. I agree, for the money seems like a no brainer versus DIY. I would like to have the bottom of the tub returned to bare metal. Hopefully they can get the undercoating off the inner fender area. Time to give them a call and get up there. I'm an hour or two south, close enough not to be a problem.
 
Undercoating is tough, it is called scrapeing, mostly with a putty knife and carb cleaner.
 
Back
Top