• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

BT7 door pillar cap installation

Share this page

P

podracer169

Member
Offline
Greetings everyone. Does anyone have a good picture of what the door pilar cap is suppose to look like installed? This is the little aluminum cap that cover the end of the furflex on each door pillar. I've search through many online photos and Healey books but cant find a good illustration/picture of how and where its installed. Thanks for your help.

Steve
 
If this is what you mean, the attached is from an unmolested (unrestored) 1960 BT7.

Lin Rose
1960 BT7 in restoration
1959 Bugeye
 

Attachments

  • 228432-IMG_7466.jpg
    228432-IMG_7466.jpg
    35.4 KB · Views: 155
Lin, This is exactly what I was looking for. Is there a piece of wood/aluminum (block) underneath the aluminum cap to make it level? Thanks for the picture and help.

Steve
 
The vinyl covered wooden block is approximately 5/8" high x 1-1/2" wide x 1- 3/4" deep. It is located to the panel below it by a self tapping screw that goes through the center of the block into the sheet metal.

Lin Rose
1960 BT7 in restoration
1959 Bugeye
 
Back
Top