Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Offline
I'm putting in my newly refurbished brake/clutch master cylinder today. I need it in place so that I can install the new brake lines. I expect I'll have to remove it again before all is done (the pedal box could really use to be cleaned and repainted), but it should be roughly assembled in the right spot.
Here's what I did (thankfully I did remember to take a picture before I removed it two years ago). Is this the correct assembly, keeping in mind that it's not adjusted at all.
Here's what I did (thankfully I did remember to take a picture before I removed it two years ago). Is this the correct assembly, keeping in mind that it's not adjusted at all.