Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
mgedit
Jedi Knight
Offline
My speedo cable in my 56 TR3 has been bouncing a bit between 40 and 60 mph. From reading other posts it seems this is most likely a cable issue. I have removed the cable and its inner core and cleaned both. There seemed to be a fair bit of oil near the transmission end, so I may have to replace an O-ring in the transmission (or simply too much oil was used to lubricate before)?
Seems that there are several recommendations about lubrication. Use a sparing amount of wheel bearing grease, avoiding the last third of the cable near speedo; use motor oil, but make sure to use sparingly and wipe off excess; or use graphite (I do have some small tubes of powdered graphite). I also have some spray silicone lubricant that I wondered about using. Both ends of the cable seem good to me, and the cable itself is new looking with no visible damage.
What (if any) is the consensus on what to use for lubrication and what is best method of applying this lubricant? Cheers, Mike
Seems that there are several recommendations about lubrication. Use a sparing amount of wheel bearing grease, avoiding the last third of the cable near speedo; use motor oil, but make sure to use sparingly and wipe off excess; or use graphite (I do have some small tubes of powdered graphite). I also have some spray silicone lubricant that I wondered about using. Both ends of the cable seem good to me, and the cable itself is new looking with no visible damage.
What (if any) is the consensus on what to use for lubrication and what is best method of applying this lubricant? Cheers, Mike
