• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

BJ7 Interior questions

Share this page

P

PeterB

Senior Member
Offline
Hopefully someone can help me. I think the guy that did most of my bodywork on my BJ7 cut out the attachments that holds the spring to the floor that goes to the top. I was wondering if anyone has a picture of where they go and what it looks like. Did I also mention the brackets that hold the backseat rest were taken out also.... I bought the picture set from British Car Specialist, they have helped out a lot just not in these sections of the interior.

Thanks,
Pete
 
Pete,
My BJ8 uses a 2" x 2" square plate, 1/8" thick with the top corners cut off at 45 degrees. It is welded to the inner sill and sticks up above the sill 3/4" with a hole in it for the spring. The centerline of the hole is 3.5" from the rear wheel arch. I would take a picture but I have not been able to post photos on this site. Hope this helps and have a good day!

John
 
Thanks a lot. I am going to assume mine is the same. Hopefully they are wrong about what they say about when you assume something...

Tanks again
 
Back
Top