Hi Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Jim_Gruber
Yoda
Offline
Was working to clean up RS on Bugsy II this AM and came across Bugsy II's Body Shell Number, 25921. Found a small spot that appears to have been partially repaired via welds. Thinking I need to close up this spot which is not accessible from behind and weld. Plan is to grind welds down and make a small patch panel over the top and weld and clean up. Any other ideas on fixing. This is in the top Right corner at the top of the bulkhead up against inner fender. Thoughts on repair please.
I used a little EvapoRust and an SOS Pad on the RS outer kickpanel. Previously unpainted and surface rusted. About 5-7 minutes with SOS Pad and some Evaporust and shiny appears underneath. Not bad after sitting indoors for 25 years.
I used a little EvapoRust and an SOS Pad on the RS outer kickpanel. Previously unpainted and surface rusted. About 5-7 minutes with SOS Pad and some Evaporust and shiny appears underneath. Not bad after sitting indoors for 25 years.
