• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

TR4/4A 4A Throttle linkage for HS6 SU

Share this page

H

HarryL

Jedi Trainee
Offline
Good Afternoon Everyone
Does someone have a good pic of the linkage setup to these carbs.
The components I have are like those on Moss pg28.
Do the throttle springs go on the inside of the levers ?
Any special advice on the throttle connecting rod & the levers ?

Harry
 
I'll try to post a pic later this evening, but the two throttle springs clip into the holes in the carb lever arms on each carburetor, Moss item 55, and then fasten or clip to the two notches on the underside of the bracket, Moss item 75.
 
Thanks for the reply- got it straightened out !
My carb lever arms don't have the holes; will place the spring on the inside arm
and if that doesn't work will drill the holes.
Hey; have a good and prosperous week everyone !
Buy low and sell high !!!!!
Harry
 
Back
Top