-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
1966 S3 Elan seatbelts
- Thread starter coldplugs
- Start date
Share this page
Vanden Perre
Freshman Member
Offline
I want to remove the existing seatbelts. Can someone help?
How do I remove the fixation on the drive shaft tunnel? Do I unscrew the bolt from the inside of the car or do I have to access a nut (our whatever) on the chassis from beneath the car?
Thanks for helping.
How do I remove the fixation on the drive shaft tunnel? Do I unscrew the bolt from the inside of the car or do I have to access a nut (our whatever) on the chassis from beneath the car?
Thanks for helping.
TypeRboy
Jedi Warrior
Offline
The nuts for the belts are welded to the chassis, both floor and rear bulkhead, so you can only undo them from inside the car. Be very careful undoing the outside floor belt bolts. The nuts are glassed into the body and are hard to fix if you strip them or break them free. Lot's of penetrate.. it's a pain when the bolts break.... ( voice of experience here )