• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

180mm or 190mm clutch plate diameter?

Share this page

BritCarFan

BritCarFan

Jedi Hopeful
Offline
The clutch plate I removed from the engine has a diameter of 180mm. The one in the replacement kit (includes pressure plate and clutch plate) has a diameter of 190 mm while the pressure plate is exactly the same as the one from the engine.

Will it be a problem to install a 190mm plate on an engine which had a 180mm one originally installed?
 
Does the new disc fit without any drag on the trans input shaft, slide easily on the splines?

Does the new disc fit under the pressure plate, not protruding past the outer edge of the plate contact surface anywhere. Does the new disc fit on the machines surface of the flywheel, again without protruding?

If yes on these three, then should be able to use it.
 
Back
Top