• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

gasket

  1. 2billydavies

    TR2/3/3A question about Figure of 8 installation

    Hi everyone... getting ready to put the sleeves/pistons back in, had a quick question about figure of 8 gaskets. First, is it recommended to put the Wellseal on both sides of the gasket? so that there is sealant on the engine block side and the piston sleeve side? And secondly, in regards to...
    • 2billydavies
    • Thread
    • figure of 8 gasket pistons rings sleeves
    • Replies: 9
    • Forum: Triumph
  2. D

    MGB MGB Side Cover Gaskets

    Posted this over on the MGE forum with mixed results- I have a 69 B roadster with engine 18 GH WE H xxxxx whis is correct for the car. As far as I know it is the original engine. Ordered the "uprated" silicone gasket set (VC + SC x 2). The old cork gaskets I have (oooolld but unused) fit the...
    • DentonPerry
    • Thread
    • gasket side cover silicone
    • Replies: 10
    • Forum: MG
Back
Top