• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

engine removal

  1. J

    TR2/3/3A Taking engine out, etc.

    I need advice from people who have removed an engine from a TR3. I have removed everything, apron, radiator, etc., starter, wires, tubes, etc., BUT the four bolts between transmission and drive shaft. They won't budge. What size are they? They seem slightly smaller than 9/16". Some British size...
    • JAJohn
    • Thread
    • brake lines engine removal
    • Replies: 16
    • Forum: Triumph
  2. 2billydavies

    TR2/3/3A question about where to bolt into when lifting/replacing engine

    hi everyone... me again! So I"m pretty much ready to put the engine back in on my TR3. I have everything together pretty much except for the carbs + accessories and things. I put the head on, thermostat, water pump... pretty much everything. Putting the tranny on tonight and i'll be ready to...
Back
Top