• Recent Articles

  • Recent Forum Posts


    Re: BT7 main bearing seals

    This thread was incredibly helpful for me guys. I just finished this process. I ended up cutting the felt rods into 1/4" lengths and using a 1/4"

    Csarneson Today, 09:58 PM Go to last post

    And the fun continues...rear main leak

    Well, the car is drive-able and I got it all dialed in after my initial startup that realllllly overheated the engine. But, it seems to idle OK and I

    ghawk16 Today, 09:39 PM Go to last post

    Re: Sign - wrong, but, oddly it is right

    Along with that other sign, the imagination can go wild.

    GregW Today, 09:26 PM Go to last post
    Drone Dog

    Lilly Engine update / couple of questions

    Everything went pretty well today. plastigauged all the rod bearings and all were right at the .003 mark. So at the top of the gap range but within spec.

    Drone Dog Today, 09:24 PM Go to last post

    Re: Stumped TR250 Running Rough--Follow Up

    Thanks to all for the replies on the prior thread, you put me on the right track.

    glemon Today, 09:23 PM Go to last post
  • Recent Blog Posts


    67 Healey 3000 MKIII BJ8

    I recently acquired a frame off restoration of a 67 Austin Healey BJ8 and the water temp gauge does not move. I had the gauge replaced once already and determined that the old gauge was not working...

    RichardOlyn 01-05-2018 12:26 PM
  • Twitter