Dash Support Cover Kit

[Cain]

Does TRF or Moss carry a TR6 dash support cover kit? I revinyled my crash pads, but I can't do the dash support because there are too many right angles. I looked on their on-line catalogs, but I didn't find one. It seems that I remember seeing one last year for around $40-50, but I can't remember where I saw it. Any ideas?

Thanks

 

[trrdster2000]

https://www.mossmotors.com/Shop/ViewProducts.aspx?PlateIndexID=32985 This should fix you right up except for the price. Wayne

 

[Bugeye58]

Cain, I believe TRF has a re-covering service for the center support through their upholstery division. I need to do the one for my GT6, and it's very close to the TR6 support, but as yet I haven't found anyplace to do it. I think the vinyl is vacuum formed over the casting.
Jeff

 

[LastDeadLast]

Cain,

TRF has the same covers for a little cheaper:
https://www.zeni.net/trf/TR250-6/index.php?menu=D&show=211

But there is a new unit on ebay for a little less:
https://cgi.ebay.com/ebaymotors/ws/eBayIS...444366&rd=1

Maybe you can get lucky and get the on on ebay.. it would save you a few bucks over the rest.

-Shannon

 

[Cain]

Thanks for the replies. I also found one on bpnorthwest.com for $88. Has anyone ever used bpnorthwest? They also have the tops for the doors that I need for $22 each. https://www.bpnorthwest.com/.sc/ms/cat/1102344159677959/9/nc/TR250-6--Interior

Yes, the price was higher than I remember. If I have to pay near $100, then I may just take it to a vinyl place and get a quote. It would be the same vinyl place that I bought the vinyl that I used to recover my crash pads so it would match.

 

[Geo Hahn]

I have used BPNW, but obviously not for the parts you mentioned. Was 100% satisfied with them.

 

[vagt6]

Cain, if you're referring to the plastic OVERLAY that glues atop the dash, please keep in mind that these overlays do not look as good as a nicely re-covered dash pad, IMHO.

I fitted one to my GT6 and it looked quite good, but not as good as if I had removed my "crash pad", trimmed it carefully and recovered it with matching vinyl. However, removing the GT6 pad is such a total pain that I opted for the cover.

Just another opinion, I hope it's helpful.

 

[Bugeye58]

I've bought quite a bit of stuff from BPNW, mostly engine internals, and have always been satisfied with the service from Bob.
Jeff

 

[Cain]

Mark,

Actually I'm talking about the dash support bracket that goes between the bottom of the dash and the top of the tranny tunnel. But, thanks for the advice.