• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

BJ& front fender/door seal. Is there one?

Share this page

R

robert_ellison

Jedi Trainee
Offline
On the edge of my front fender, from top to bottom along the outside line of the hinge piller there are a series of holes drilled in the fender flange. I wonder if there was a seal that connected to the fender to seal that edge of the door/fender, other than the one that runs down each door and along the sill trim plate. I have seen a scuttle seal for them up to the BT7 but no reference for the bj 7.

Any info would be appreciated.

Robert
 
Nope, there was no seal at that location requiring screw attachment. If the fender is off the car those holes are probably used to attach the fender to the A post---Keoke-?
 
Re: BJ& front fender/door seal. Is there one?

The seals that run down along the outside edges of the winshield frame take an almost 90 degree turn outwards and are then fastened to the " back edge " of the front fenders. They don't go all the way down the edge, just to about where the upper hinge height is. .... There are holes along this edge so you could pop rivet the seal to the fender edge to keep it in place.
 
Back
Top