There is a chrome plated brass molding that attaches to the top of each door of the BJ8. Moss numbers are 805-190 and 805-200. The do not appear to have been attached by any mechanical fastener, with the exception of the clips that also hold the rubber window seal. There was, however, a strip of adhesive apparently providing some bonding between the molding and the door. The ends of the molding do have flanges that seem to fit around the door somewhat. Other than what I have described here, is there any other attachment procedures for this molding? And question number two: does the rubber outer window seal overlap the side window channel? Thanks a bunch.