I have a 1959 100-6 that came with and overdrive but a non overdrive transmission. I found and bought a used overdrive mainshaft that is in excellant condition but it looks like the cam on it is on backwards. I have an old manual but it doesnt show the mainshaft orientation in the overdrive. When I slide the shaft in the overdrive the cam doesn't reach the plunger which I assume is like the oil pump. Is the someplace I can get more detailed drawings/instructions? Also, the overdrive turns freely and I was thinking of just flushing it out with some solution and putting on new seal and gasget. Any advice. I will need lots more advice when I get to replacing the tranny mainshaft. I can send pictures if needed.
Thanks,
Chuck
Thanks,
Chuck