Giovanni59
Freshman Member
Offline
Hi,
I am putting the after market fan back on the engine of my 1965 TR4 and there are two plates with holes that go over each set of bolts.
One is flat and the other is curved. I am not sure if the curved one should be hammered flat or is it curved for a purpose. It does not fit over both bolts in this curved state. The curved bend looks intentional. I do not even know what their purpose is.
Photos attached. I have owned the car for about 6 years and they have always been on there, however I never noticed them until now. The only thing that it reminds me of is in the electrical field where they need to be connected to complete a circuit. Thanks
I am putting the after market fan back on the engine of my 1965 TR4 and there are two plates with holes that go over each set of bolts.
One is flat and the other is curved. I am not sure if the curved one should be hammered flat or is it curved for a purpose. It does not fit over both bolts in this curved state. The curved bend looks intentional. I do not even know what their purpose is.
Photos attached. I have owned the car for about 6 years and they have always been on there, however I never noticed them until now. The only thing that it reminds me of is in the electrical field where they need to be connected to complete a circuit. Thanks