Willie_P
Jedi Hopeful
Offline
hi-
can someone real-quick provide me with the proper torque values (I was looking in the workshop manual and did not immediately see these):
+wire wheel spline-drive studs to hub face (front and rear, the actual studs (four per wheel, I think) and special nuts)
+the rear hub/bearing carrier to the axle housing flange(6 bolts per side that thread directly into the rear hub)
+the propshaft flanges where they mount to the tail-end of the gearbox and to the rear pinion flange (four bolts per flange).
thanks! -wes
can someone real-quick provide me with the proper torque values (I was looking in the workshop manual and did not immediately see these):
+wire wheel spline-drive studs to hub face (front and rear, the actual studs (four per wheel, I think) and special nuts)
+the rear hub/bearing carrier to the axle housing flange(6 bolts per side that thread directly into the rear hub)
+the propshaft flanges where they mount to the tail-end of the gearbox and to the rear pinion flange (four bolts per flange).
thanks! -wes