TexasKnucklehead
Jedi Knight
Offline
I have a new set of brake lines to install on a clean frame (1958 wth Girling). The ones I pulled off were obviously not routed the same as original. Some looked like both ends were attached, then a foot was used to press the excess out of the way -not to mention extra couplers. I have printed out Don's right and left rear (thank you Don Elliott) and routed the front passenger side, but the drivers side is not as clear. I assume it goes up along the frame support rail, down and under the engine, then back up the rebound mount? Anyone have a picture?