Tabcon
Jedi Warrior
Offline
I was wondering if any of you gentlemen may be able to help me with this problem. I had to get a new front cover, seal and gasket for where the input shaft enters my gearbox through the bell housing, and I'm having some difficulty setting the seal to the base of the housing. I see in the factory manual that there is a special tool for this, but alas, I ain't got one. I've managed to get it about 1/8th of an inch from it's home, but it's so tight I'm afraid to pound on it any further. I was thinking I could use a large socket to push it down with, but all the ones I have are either slightly too small or too large.
Any thoughts?
Gracias!
Any thoughts?
Gracias!