-
The Roadster Factory Recovery Fund - Friends, as you may have heard, The Roadster Factory, a respected British Car Parts business in PA, suffered a total loss in a fire on Christmas Day. Read about it, discuss or ask questions >> HERE. The Triumph Register of America is sponsoring a fund raiser to help TRF get back on their feet. If you can help, vist >> their GoFundMe page.
-
Hey there Guest!
If you enjoy BCF and find our forum a useful resource, if you appreciate not having ads pop up all over the place and you want to ensure we can stay online - Please consider supporting with an "optional" low-cost annual subscription.**Upgrade Now**
(PS: Subscribers don't see this UGLY banner)
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Allison/crane xr700 install
- Thread starter Palm67
- Start date
Share this page
Yes otherwise the pickup won't fit in!
Now to get the pickup in approximately the correct location, turn the engine over until the #1 cylinder is at top dead center (on the firing cycle, both valves should be closed)
Now move the crank back to about 10° before top dead center. Now put the sensor in, with the center of the sensor lined up with one of the slots on the disk, and tighten it all up. you will be close enough to the correct timing for the engine to start, and then you can set the timing with a timing light.
Make sure that the disk is well centered or the timing will not be the same on all four cylinders.
Now to get the pickup in approximately the correct location, turn the engine over until the #1 cylinder is at top dead center (on the firing cycle, both valves should be closed)
Now move the crank back to about 10° before top dead center. Now put the sensor in, with the center of the sensor lined up with one of the slots on the disk, and tighten it all up. you will be close enough to the correct timing for the engine to start, and then you can set the timing with a timing light.
Make sure that the disk is well centered or the timing will not be the same on all four cylinders.
Similar threads
Similar threads
-
-
-
K
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
G
A friendly reminder - be careful what links you click on here. If a link is posted by someone you don't know, or the URL looks fishy, DON'T CLICK. Spammers sometimes post links that lead to sites that can infect your computer, so be mindful what you click.