Thinking about replacing the camshaft while waiting on manifolds and triple carb setup. Will have front frame engine compartment brace, radiator etc already pulled to replace timing cover seal.
Can I replace cam while I am at it. I remember another post that mentioned engine had to be jacked up to get the cam to clear the front body opening. Can this be accomplished by merely loosening engine mounts?
Seems simple enough if can be done without pulling the engine but hate to get into it and find out the guts have to come out of the car.
I understand it is somewhat of a challenge to do without also pulling the head but with a fancy magnet tool and several extra hands should be accomplishable (is that a word).
Trying not to fool with an engine that has been rebuilt too much but is it a mistake to replace only the camshaft? I know there may be other issues that pop up but what should I pay attention and look for in this adventure?
Apologies in advance for the long post and too many questions.
Can I replace cam while I am at it. I remember another post that mentioned engine had to be jacked up to get the cam to clear the front body opening. Can this be accomplished by merely loosening engine mounts?
Seems simple enough if can be done without pulling the engine but hate to get into it and find out the guts have to come out of the car.
I understand it is somewhat of a challenge to do without also pulling the head but with a fancy magnet tool and several extra hands should be accomplishable (is that a word).
Trying not to fool with an engine that has been rebuilt too much but is it a mistake to replace only the camshaft? I know there may be other issues that pop up but what should I pay attention and look for in this adventure?
Apologies in advance for the long post and too many questions.